Hi Ole,
i assume you speak english?
I didnt watch the video in its full length, i just did skip through it when i saw what you were doing. Also i hat to watch it on mute.
This is no way to test the tourque of any driver, because the tourque needed to open a set screw is always different from the torque wich was used to fasten it. Its a common mistake which you can find all over the internet.
Everyone who ever hat to focus on tightening of threats cringes when such "tests" are made.
Next point is that these kind of machines isnt build for this kind of work.
On the
german website, hard torque is ratet as 50Nm, in the actuall manuals also. If there is an older revision of the manual stating otherwise, i assume it to be a mistake wich was corrected in the next revision.
Maria, Maria, i like it laut!
